Analog to Digital Converter

For-A
Analog to Digital Converter

The UFM-100ADC is a module-type A/D converter that can be installed in a UFM frame. Analog composite, Y/C, and analog component input can be converted to SD SDI for output. Includes analog composite, Y/C, and analog component input.Two SD SDI outputs9-bit A/D, 27-MHz oversamplingAdjustment of luminance level, chroma level, and chroma phase.Reference signals can be input from a UFM frame or rear module.

Specifications
Standard	NTSC (525/60) & PAL (625/50)(Auto detect)
Video Input	Selectable as below
Analog Composite	1.0Vp-p, 75?, 1ea., BNC
Y/C	Y: 1.0Vp-p, C: 0.286Vp-p(NTSC)/0.3Vp-p (PAL), 75?, 1ea., BNC
Analog Component	Y: 1.0Vp-p, R-Y/B-Y: 0.7Vp-p, 75?,1ea., BNC (Selectable as Betacam level or SMPTE/EBU level)
Genlock Input*	BB: 0.429Vp-p (NTSC)/0.45Vp-p(PAL), 75?, 1ea, BNC (Also signal input from UFM Frame)
Video Output	Digital Component: 270Mbps, 75?,2ea., BNC
Quantization	9-bit
Sampling Frequency	Y: 13.5MHz, C: 6.75MHz
I/O Delay	Max. 1 frame
DG / DP	Less than 0.3% / Less than 0.3°
HV Tilt	Less than 1%
DC Output Level	0V ±10mV
S/N Ratio	Better than 60dB
I/O Delay	11.3° (±1°) ,Approx. 8.8nsec
Frequency Response	100kHz - 5MHz: ±0.3dB, rolloff above 5MHz (NTSC) 100kHz - 5.5MHz: ±0.3dB, roll off above 5.5MHz (PAL)
S/N Ratio	Over 60dB
Linearity	1.5%
K-Factor (2T pulse)	1%
Process Control	Video Level: -50% - +50% Chroma Level: -50% - +50% Chroma Phase: -30° - +30°
Temperature / Humidity	10ºC - 40ºC / 30% - 90%(no condensation)
Power / Consumption / Draw	Supply from UF frame, +12VDC -+24VDC / Approx. 3.6W / +12VDC: Approx. 0.3A, +24VDC: Approx. 0.15A
Dimensions / Weight	Fit to UF Frame, 106 (W) x 303 (D)mm (Front board), 18.5 (W) x 66.1 (D) mm (Rear board) / Approx. 0.5kg
Require Slot	1 slot
Accessories	Operation manual